Modkin 1 Inch Scope Rings Set of 4, 2 Pieces High Profile Scope Mounts and 2 Pieces Medium Profile Scope Rings for Picatinny Rail

These might be suitable for a cheap BB gun but that's about it. They will not sit level and one mount sits differently than the other. They will also not sit flat on top of the rail. There is metal protruding from the bottom that would scratch the rail if I tightened them down. The angle is not correct on one side of the picatinny mount.

Good rings but order said I was getting 2 sets and only received one.

The fastener that is embedded into this ring is so poorly affixed, that when mounted it sits at an eleven degree slant from the top of the rifle. Each fastener was tapped at a different angle. No two rings were similar. Very poor craftsmanship. I wasted my time and money with this purchase.

Absolutely do not use on anything larger than a 22lr . Mounted these on a budget .308 Savage and after about 10 shots the studs holding onto the rail started to pull through - causing them to come lose .

The threads for the screws strip easy not only that they do not fully encompass my scope, so they’re not flush when you’re screwing them

Neither of the two different sized scope mounts that come with this order fit my 22 rifle. The bolt handle would strike the scope every time I attempted to eject an empty casing. I bought a local scope mount and it fits perfectly!

when tightening the scope these are impossible to keep the scope level even when tightening at the smallest increments i will never buy this brand again total junk and a waist of money

Do not buy these if you want a reliable scope mount. You will spend a lot of time and money zeroing your scope, only to have these mounts fail and throw everything off. There’s no point in going cheap when the integrity of your shot relies on your scope staying in place.