CarBole Micro Electric Gasoline Fuel Pump Universal 5/16 inch Inlet and Outle...

Does everything I want for my Holley 650 4 barrel carburetor on my truck -1975 IH 1600 -------------------- I have been asked a lot of questions by people from Amazon about this fuel pump. The biggest question I get - will it work on a particular model. Sometimes I can answer that question, while others are not sure. When it comes down to carburetors each has a certain PSI for fuel pressure rating. These need to be match. If a carb is rated @ 6psi then the fuel pump should be @ 5 PSI or a little less . If you get too much PSI, the float in the carb WILL NOT shut off. This will cause the carb to flood fuel everywhere in & on the engine. Not enough PSI might cause low fuel delivery. The other item is GPH {gallons per minute}, in most cases this is not important issue, unless you got a rocket vehicle that needs massive fuel delivery. Also I have been asked about the mounting positions, I always try to mount it feet down and also close to the fuel supply {tank} as possible. A general rule to any type pump, it can push liquid farther than it can pull it {from tank}. Hope this helps.

Stopped working after 2 weeks. Checked fuse checked relay everything in working order. Except pump. Don't know what's going on.

supposed to have a 12 month warranty. followed instructions for warranty and guess what, YOU DON'T GET ANYWHERE! they blocked any attempt to do warranty contact! this thing quit after 1 week. bought a second one to get the car running quickly and it stopped after 10 seconds of install. BTW, I'm an experienced auto mechanic with over 40 years experience! I know what I'm doing!

This little pump was very inexpensive, so I was hesitant to try it. But it works great. I used it to pump 85 gallons of fuel out of my boat and it finished the task with no problem.

@weaverstonehousefarm on YouTube Pressure is 7psi on my gauge in the video. Even at full throttle on my IH 444 tractor it works fine. The bolt holes line up with the factory pump holes. It has a 5/16” smooth barb outlet connection for a rubber fuel line. It’s can’t be removed or replaced. I wish that outlet was threaded. There are other models with a threaded outlet. Inlet is threaded. Possibly 1/4” FPT. I got tired of every 3-4 years replacing the $60-80 dollar pump from NAPA. For the twenty something dollars it will work and looks similar. I tried this higher pressure pump as the 2-3 psi pumps would barely put out 2psi. Wiring was simple 12+volt DC positive and the ground wire to the bolt for the base. It comes with mounting bolts. We make hay and run our equipment in the worst and hottest parts of the summer so it’s expected that and electric fuel pump w/o any external cooling will eventually fail for us. It gets so hot sometimes when making hay the fuel will boil in the tank.

Day 2 and it still works. Required priming first before attaching to the vehicle fuel line. Used Teflon tape to install filter and it seeped. Used orange high heat silicon over compressed teflon and it is staying bone dry. Use a backup wrench on the pump flat to tighten filter. It would be wise to carry a second pump, WD 40 for priming and tools just in case.

quiet operation. Will not shut off. No customer help

It didn't last about last only for about 2 weeks was only using it for a primer pump

Todo me gustó el diseño y cómo fijarlo y su funcionamiento y resistencia

Works perfectly up to now.

Works well.

Solamente sirvió como 5 kilómetros y luego se descompuso. No es una bomba robusta.

Compré 1 y duró 8 meses, compré otra porque me gustó lo silenciosa que es y la siguiente opción de mejor calidad cuesta 3 veces mas