Xprite 4D Smoked LED Tail Lights Compatible with 2007-2018 Jeep Wrangler JK JKU, Plug & Play Rear Taillights w/Built-in Resistors, Parking, Brake, Turn Signal & Reverse Lights, DOT Approved

I replaced a much more expensive brand tail lights that caused me to lose my brake lights and turn signals. These light were going to be a low-cost temporary fix but after installing them in 10 minutes I quickly realized they were better quality than the previous lights. The wiring was all plug and play. They are crystal clear and the back-up light is Super bright. Not sure how long they will last, but so far, after three months they’re going strong. I would highly recommend these lights.

Easy to install and are very bright. Reverse light is awesome.

Perfect fit bright works as described, looks awesome great value for the money would recommend this product

Easy to install. Great quality. Fit perfectly

Great looking light, but 3 LEDs have burned out in the passenger side. Installed the lights about 2 years ago, and it's out of the warranty period. Not an expensive light to replace, but there's very little actual use on them, so I expected them to last longer.

I would recommend these tail lights. I replaced the stock ones on my 2015 Wrangler. These are quite a bit brighter and look good in the daytime as well since they are smoked

They are quite easy to install, and are a lot brighter than the factory tail lights

WOW! I can’t say enough about these lights. I went with the clear lens, just for added brightness. They were really easy to replace. Just unscrew the OEM light housing and connector, then reconnect the new lights, reversing the process. Literally took me less than 10 mins per light and that’s with me adding a little dielectric grease to the connectors. Don’t know how long they will last, but they appear well built and the black w/ clear lens looks sharp against my silver and black Jeep. The LED’s make a huge difference in daytime visibility, but let me tell you…. Those reverse lights at night are freaken amazing. A side note. Those metal aftermarket lens guards won’t fit over these lights due to the backup light section being a slightly raised area. I guess if you could find longer screws and some rubber spacers you could mount the guards, but otherwise the screws are not long enough and without some spacers, you run the risk of cracking your new lenses.