YONICO Router Bits V Groove 60 Degree X 1/2-Inch Diameter 1/4-Inch Shank 14993q

Used the 45 degree bit for some router carving, and it cut pretty smooth, only a little bit of sanding needed to bring it to a nice 220 grit finish. Very fragile though, like all router bits; it rolled off my worktable and hit the ground, shattering the point. I just ordered another one, they're inexpensive enough.

This is a nice set I mostly bought for the vee bits but the bullnose is nice too

I buy these a lot. They don't last super long when v-carving hardwoods, but if you drop and chip one, you don't cry because it was under ten bucks!

This is a great product. It save me, I had to router a plywood discontinued design for my client. Very sharp and did what it promised. Thanks!

Good value for the money.

I hate writing three star reviews, because nobody reads 3star reviews. But This bit doesn't deserve fewer stars nor more stars.I used the bit to cut 12 countersinks 3mm deep in 8020 aluminum extrusions. It did ok, but is pretty shot now. I don't fault the bit for dulling after cutting aluminum -- I was using a CNC router running at 13000rpm with no flooding -- so not the best procedure.The bigger problem is that the 1/4" shank was either slightly oversize, or slightly flared on the end. I tried two different collets and could not insert the bit deeper than 1/2", and that depth required a lot of force. I've not had any problem with any of my other 1/4" shank bits.Even though the aluminum dulled the bit, I likely could still use it in wood, but because of the problem with the shank, I'll probably just junk it.All that said, the bit arrived on time and overly packaged. Price was very low. -- And, in the end, it did do what I needed it to do.

Router bits work very well on cnc projects and last.

As a serious wood working hobbyist, Yonico makes a good product. These work very well.

Good edges on cutters, delivered quickly. Thank you

Purchase this to route a vee detail in home made skirting boards.So far it’s done 40 metres of MDF and still going strong.

Great price for a good quality tool, I've used it several times so far for routing out lettering in wood. Clean cuts.

Good wee bit, seems sharp, used it maybe four times now, only thing that I've noticed is that the yellow covering is peeling in one sharp junk, not sure if it will affect performance or not but I doubt it, for the price though did the job...(uses for sign making)

Well we have bought these many times and they have always been good but this last 20 are NOT 90 degrees so they are useless to us