iGreely Dual Positive/Negative ATC Style Fuse Holder 10AWG Wire with Ring Terminals and 45A Connectors for Automotive 2ft/60cm

As with all Amazon products, they push for a review pretty quick. This is a good quality, accurate gauge wiring. If it causes issues, I'll be back but I don't expect trouble. Looks solid!

Using this to connect solar cells and 20A solar charge controller to RV lead acid deep cycle batteries. Hoops fit on the batteries no problems. Other end has 45A Anderson connector. All appears to be heavy duty construction. Two built in fuse holders, one on positive and one on negative. Comes with 15A, 20A and 30A fuses.

Use to connect a battery to a solar power station to extend the battery life. Works as intended and connectors are good quality.

I purchased two of these cables used to chain 2 additional batteries to my Goalzero Yeti 400. I was very happy with the purchase, since they worked out flawlessly. I chose these particular cables, because they were 1 foot longer (and the longest I could find) than another product.There was 1 little issue that was easily fixed in a few seconds.. The +/- anderson connectors need to be individually turned (by sliding down the plastic/rubber sleeve & sliding it back up when done) to place them in the correct position to connect. Out of the box, the connector pins are not facing the same pin position as the one on the Goalzero.

I needed a power cable to go from the battery to my HF Ham radio and this fit the bill because it had Anderson Powerpole connectors. My only comment the ring connectors on the battery are almost too large to fit my Eco-Worthy battery. A couple of washers solved that problem.

Quality copper wire, terminals and fuse holders. but the Anderson Power Pole connectors were assembled improperly. The Red and Black Power Pole connectors should be connected side-by-side in the standard fashion (documented on Anderson Power Pole website and others). This item came with the connectors attached one on top of the other, thus will not mate properly with a standard pair of power pole connectors. It is relatively easy to rectify - you can detach the connectors from each other and re-attach in the proper orientation - but you kinda got to know what you're doing.

Product installed in minutes. Attached a 2nd battery to a Yeti 400.

I ended up returning this item. From the outside it seemed well made. I had it in line between my UPS battery and my UPS. After getting the system assembled I was load testing the system i had about 5ft of 10GA wiring. All copper wire was used and this fuse was inline for protection. I had less than 20A of draw being placed on the fuse.I disconnected the power supply from the 110 power source. The test was to last for 5 min which is how long it takes my UPS to determine that the power will not return and have completed the shutdown of my three servers. Using a IR thermal gauge, I was monitoring the wiring between the UPS and battery and the UPS itself. In the first minute the temp on the thermometer has hit over 100F by then end of the second minute the temps has peaked exceeded 210F. The fuse assembly was starting to stink like melting plastic. I reconnected the main power feed line and stopped feeding from the UPS.I removed the fuse holder from service, I am not sure if the fuse was adding resistance due to a poor connection inside the housing or if the internals are improperly sized for the appropriate 10GA max load of 25A-30AI redesigned the UPS wiring system and used a different fuse system instead. Always test to the rated load limit, Please be safe!!