Fencemate Drive In Tool For Up To 3 X 3 Drive In Metal Post

I am far from overjoyed with this item. It is significantly inferior to my last one purchesed fron a chain diy store. The plastic body has been chopped from a longer length but not cleanly and at a slight angle so there is an increased risk of personal injury when using the item. It will also promote the post not being driven cleanly. One side of the body has a metal plate crudely screwed to it with two small wood screws when there are three holes for screws. The metal bar has also not been cut cleanly, not properly filed smooth on the ends but galvanized in an unfinished state.If I e er need another one of these, I'll get it from the diy store rather than risk poor quality like this one online.

Fencemate Drive In Tool For Up To 3 X 3 Drive In Metal Post ,good tool.

The block worked well for the limited number of spikes driven. After 10 posts the block was deforming

Poor quality weak and shoddy

The product is useless as the bar does not fit in the holes in the block. Cannot recommend on any level.

Absolutely useless. This item has a thin metal plate screwed to the bottom whicheck is bigger than 75mm square and was put on wonky. Even without the plate it still wouldn't fit into the met post holder - not fit for purpose.

Got 1 of 3 Metaposts half in when it split down the middle.Held it together with large cable ties and gaffer tape, did the job.

the rod on the drive in tool damaged the sockets and also bent