Generic Mouse Skates/Mouse Feet for Logitech MX Master (2 Sets of Mice Replacement feet) (5741986)

Fitted perfectly after I has to peel the originals ones off to remove screws

Had to take apart my 1st gen MX to due to a sticky side button and needed to replace the sliders. I've used others in the past that worked fine. However they were out of stock so ordered these instead. Perfectly cut and the mouse slides freely as the ones from the factory.

The stick seems solid, mouse glide with is them nice and smooth.Just two issues- they're smaller than the originals, so definitely going to gather dust etc around those edges at a high rate.The bigger issue for me is that I bought them because I'd worn down the previous skates to a point the base of the mouse was catching, and these are definitely thinner than the originals, so likely to reach that point again faster.

I bought these for my MX Master after needing to open mine to fix the gesture button (I ruined one of the original pads).These are perfect and easy to install. Just remember to remove the protective film over them once applying so they glide properly.

Pretty rubbish really, I paid nearly 7 quid and got a few bits of badly cut out rubber. The mouse feet do not cover the same area as the original, so there is a gap now where all the lint and dirt gets stuck to the side of the mouse feet. The profile is also slightly thicker so the mouse doesn’t sit flat on the mat. I will be returning this asap. If your thinking of buying this then look at other models cos this is rubbish and the ratings and purchase qty will mislead you into thinking this product is a good solution, it isn’t.

Ok for replacing worn out pads, but I don't think they are as good as the originals. Not as smooth as I had hoped. Note they were installed very carefully. Pads are about 1mm smaller than the grooves on the mouse, not sure it makes much difference, but may collect dust and the pads can be slid around once stuck. It did give me a chance to open up and clean the mouse, at least the scroller feels like new. At £8 I'd stick with buying Logitech ones, they were only instock in the US so I bought these as I was in a rush.

These somewhat fit the MX Master 2S, they are cut slightly smaller (say, 0.5mm all around the edges) than the gaps they're meant to fill. However, they are quite glossy and slide very well and adhesive seems strong enough.

Dont even resemble the mouse - see image.

Fits MX Master 2S fine. As other reviewers said it might be about 1mm too small. Remember to remove the very thin protective coating off the top after you install them. If you accidentally leave that on it will not glide smoothly.

Works like the original.It is great to have another one for the next battery replacement!

Collage parfait

Perfetti per il modello di mouse in descrizione.

The pieces were easy to use and fit perfectly and work well, just remember to remove the very thin, almost invisible protective film!