Watersnake 3-Bladed Propeller Kit 44-54lb

This prop is made to ride on a 3/8 inch motor shaft. The way you assemble it is you install a 1/8 inch pin in a hole in the shaft, slide the prop on, then install the nut (which clamps the prop against the pin). This "Kit" comes with a pin and nut (which would be easy to lose), so it should get you going again if you've damaged another prop. The nut is 3/8-24 thread.The outside diameter of the prop hub is 3.5 inches with the blades extending ~4.5 inches from the shaft center. It is intended for any watersnake motor with a 44-54 lbs thrust rating (where the model will have the numbers "44" or "54" in it, like "SWET44", "ETW54", etc). Otherwise I hope the info given will allow you to see if this will work on what you have.

I am sending it back! Its a 8 inch propeller and should be a 23 inch!

The packaging was good.The prop is exactly like the original.Just mount it up tighten the nut and go for it.

Works exactly like the old one did, and I loved that one, so no complaints here. Great propeller for weeds, brush etc.

Got it delivered fast. Looks to be exactly as described in original packaging.

relpaced a damaged prop. the propeller is not very durable.

I suppose it will work as it is suppose to. I bought this for a back up.

works great.

Haven’t used it yet but I have no doubt it will make the boat move. What I can tell you is that it fits perfectly on an E Thrust 55lb motor.10mm shaft, 2.9mm shear pin.