Pyle 2 Channel Car Stereo Amplifier- 1400W Dual Channel Bridgeable High Power MOSFET Audio Sound Auto Small Speaker Amp w/ Crossover, Bass Boost Control, Gold Plated RCA Input Output, Black - PLA2200

Great powerful amp, looks cool, sounds good, great value and price.

Excelente producto cumple con todas las espetativas.

Nice addition, old amp finally quit, this brought back a sound that fit the bill

Works great. I have it on 2 10” subs. Way more power than needed.

After I finally got around to having this amp installed, I was pleased as punch to having a little bass in my trunk. It sounded decent, for the price, and filled out the low end nicely. Unfortunately, the success was short-lived. After the first day (and literally less than 4 hours of use) the amp stopped working. I checked to see what had happened and the two 10-amp fuses on the amp were both blown. Perhaps I had the levels turned up too high, so I can claim responsibility for blowing the fuses (even though I'd think the built-in protection circuit would trip before the fuses blew - which it didn't). [Note: I'm using this amp with the Pyle 12" 600W sub, which you'd think would be a tested match]. So, I replaced the two fuses and expected to be back to normal. WRONG. Now when I turn on my radio with the volume on the lowest setting, the amp turns on for a second and then immediately goes into "protection mode" (the green light turns red). This means no sound from the amp. All of my other fuses are in-tact, but for some reason, the amp just won't stay out of protected mode. Given that it's broken so quickly, I'd say stay away.

I'm a Pyle fan and have been for years they make great speakers and amps this amo blends with a 5 year warranty

What else do you need to know? It's not something that's going to push your subs, it's not going to make everyone around you feel what you're listening to so if that's what you're aiming for I'm going to detour you somewhere else and I apologize... Mine worked for over 2.5 years... Why did it stop working? I helped someone jump their car, I hooked up my end, they didn't hook up theirs right and the surge fried the amp... What you need to know: This is a good amp, nice quality, and easy to install. It lasted for a really long time for me, and would still be going if people weren't retarded, but hey, mistakes happen right? I got my use out of it, and I hope you will too... I used this Amp with the Dual Bandpass 10' subs with the neon light rings around them. The case is gray, and the middle has a clear panel, with four silver plated air holes on each corner. they were 1k watt subs, so this didn't push but 700 to each (though on my review I wrote 500 because I never really turned this amp all the way up). This amp does get hot, please be aware of this, but it's a good product. Thanks for readying and good luck to you all!

I liked the price which is why I'm sure ALOT of use bought this amp, When the amp hits it hits hard , but even with the gain turned down low and all the bass turned off at the deck , the amp will start to get hot after 4-5 songs and shut off to cool down, once it's cooled down your back to bass , that is until it gets hot again repeat process. I have the 1400x2 amp , on 2 fosgate 10s p3s The amp does not handle the base at all. I give it a 3 star because when it is cold it works great, it's price effective, however there is no longer car rides and enjoying your music loud with this amp

Excellent great looking amp, works perfectly and pumps out volume just how I like it, LOUD! Very happy with this purchase

Not sure that the item should have silver screws and a photocopied manual???

It was ok not happy that when you purchase this amp that if you are not satisfied you can not return it