Dasen 2" Rear Receiver Trailer Tow Hitch Compatible with Kawasaki Mule 600 610 2005-2016, fit Mule SX 2017-2025

Only one of the 5 mounting holes lined up. All holes had to be enlarged, and not just to fit. After enlarging holes to fit, I had to enlarge them further just to be able to adjust it to be straight. It is however, sturdy once mounted, but it's not a $72 hitch, unless it was 100% bolt on and go. The metal was quite easy to drill also, so it's not extremely hard steel. This should be a $30-$40 mount for the metal softness and requiring fitting as most consumers are reporting.

The holes aren't drilled spot on so it takes some prying. The directions are vague. I suggest replacing the muffler bolts with longer ones and shimming the space between the muffer bracket and the hitch braket. My opinion its a $35-40 design but still cheaper then OME dealer options.

I guess any after market product is going to have a few installation problems and most of the holes had to be enlarged.Several welds on the vehicle made it impossible to install it without enlarging the holes. Once installed it will do the job.

As noted by other reviewers, the holes aren't quite drilled right, I had to make one bigger to be able to get all the bolts in. A bit frustrating, but once done it is very sturdy and I am happy.

One of the three rear bolts wouldn’t fit. It interfered with a factory weld. The two tabs that bolt to the exhaust brackets don’t fit at all. I’ll weld some brackets and make it work but I’m disappointed it needs modification.

As others have said, the holes are not drilled correctly and the metal is very soft. I question the strength of this. If I didn’t have to enlarge every single hole, I’d send send it back. Maybe worth $30. Not over $70!!! Cheap China crap!! Do Not Buy!!!

This does not fit a Kawasaki Mule. If you want it to fit you will need to modify the holes which will weaken the strength of the product. Poor quality control.

I like that it has chain hookups, sturdy and well built. Had to make minor adjustments to one side, made holes bigger, to clear body frame/tubing. Holes on the upper bracket did not align with the exhaust bolts, another adjustment.