XtremeAmazing Set of 4 Flow Matched Fuel Injector Nozzles for Toyota RAV4 2.0L 2001-2003 23250-28050

They worked, fixed the lean code 2002 rav4 . While you have the intake box off, run it after installing to see to see if the orings seal. Two of them rolled easily and leaked. Used a couple of orings off the old ones and they sealed right up. Cant beat fixing the problem for this price. Would recommend.

I purchased these through amazon as a Hail Marry. I contacted Napa and other Auto stores to purchase Injectors and they ran roughly 148.00 for each. X 4 = Amazon search for Injectors on a DIY.Found these for less than 50.00 IN TOTAL for all 4. I did the install and cranked the engine... and of course the fuel was spraying everywhere from the fuel rod site. The small o-rings did not hold and were so flimsy that they twisted upon install causing a massive leak.I went to Harbor Freight and purchased an assortment of o-rings that can withstand natural gas and other harsh chemical based fluids. ($4.99).This was the fix that was needed. The car runs AMAZING, no issues and my gas consumption has improved drastically.Buy this and O-rings. You'll be good to go!!

They worked and fit good

I give them 3 star because no questions ask,after I have them installed them 4 dias after I smell strong odor of gasoline, I found out was coming from the gasket on top and bottom of injector bad quality gasket.

The small O-Rings that fit into the fuel rail are way to big on the inner diameter. They are not a snug fit and when you fight to put them in the rail, they roll out the bottom. The large O-Rings are not the best fitting either. After several tries and dangerous fuel spraying everywhere, I ended up going to the parts store and buying a set of felpro O-rings and then they finally worked. It was a lot of extra time, money and a dangerous situation due to the fact the manufacturer was cheap by supplying the wrong o rings

I find it hard to believe this cheap Chinese junk installed without trouble and worked perfectly. Even the o-rings that came with it did not leak.what may have been a factor is that I cleaned everything best I could. that means the area on the cylinder head around where they pop in and the hole they slide down into brush it out spray it out with ether clean everything put a dab of grease on all the o-rings and take your time. If you have an injector you suspect of being bad with your old ones mark it before you take it out. So that way if one of your new injectors isn't working you can select one of the good old ones to put in its place for the time being. Check your PCV valve while you're down there.

Fit correctly with fel pro o ring kit. Lean code went away and better acceleration.

They run rich in my RAV4 had to step up to a better brand