1/2 Clean Cut Sleeving 25 feet Black

Does what it's supposed to

Superb!

The biggest things I put through this 1-inch size was a regular US 120V 3-prong power cord, plus a VGA cable. I staggered those two ends a couple inches apart and didn't have any problem inching them through a few foot run between PC and wall. It looks way nicer than zip-tied cables! Plan ahead and don't forget the USB webcam or Audio wire or whatever. I didn't need VGA but I put one through just so I'd never have to take it apart later, and if I want to remove it I'll just cut off an end rather than un-stretch it. You have to push, not pull, like a "Chinese Finger Puzzle" toy. The more diameter of cables you end up having inside this, the less it will stretch out so you have to guesstimate a little before you decide how long to cut it so you can stuff your cables, or else you could just feed your wire most of the way before cutting and then cut it once most of the cable is pushed through. The stock end where it was melted had to be stretched open, and once the cables are in it I don't see how you could really melt the ends again safely, so if I wanted really clean ends I would add some heat shrink rather than trying to melt this directly.

For years I've been taking my guitar synth rig (GR-33) to gigs which required laying four cables from the foot controller to the amp or PA. I tried wire ties - too sharp and cut my hands. I settled for taping them together with electrical tape every foot or so. I called the bundle the beast. FINALLY, I found this product. I was able to slip all four cables into it - three 1/4" hi-impedance (guitar) cables and one power connector - without taking the ends off. The product expands to 400% its size. It took a few minutes to figure out how to do this easily as the webbing acts like a Chinese finger puzzle. Once the cables were covered, I slipped 3/4" shrink tube over the ends to hold down fraying and shrank them down tight. Even when used carefully, this product DOES fray on the ends once cut. Shrink tube handles this problem perfectly and professionally. I no longer call my little bundle of cables the beast. Highly recommended.

I'm using this in my car to tidy up the wires in my stereo installation. It certainly did the job of making my work look professional and uncluttered. The mesh material seems durable, but given my application I can't tell you if it will hold up to extreme conditions. The mesh does fray a little when you cut it, but I don't think it's possible for mesh to be 100% resistant to this. You can however, melt the ends, and the minimal amount of fraying you do get becomes a non-issue. In conclusion, this product met my expectations. My only gripe is that the price tag is awfully high. But, like many things, I suppose you get what you pay for.

This 1" Sleeve, by Techflex, is at least the fourth brand of sleeve I've purchased through amazon within ~ 18 months, all costing relatively same. It's weight, texture, smell, ease of application reminds me of mil-spec braid used to protect wiring/cables of aircraft electronics. It's a mirror image of it. Its ends don't unravel like others I've used, and, despite branded "1-inch" I 'inch-wormed' it over several 1.5" cable weaves with ease. Top quality braid rendering highly professional results. My 'project car' is looking awesome; I will be buying more Techflex of different diameter. This is the good stuff and wager is/near mil-spec ... Definitely Recommend. Kyle ain't a lapdog

Perfect size for 1/0 gauge, or a bundle of wires. pretty gal dern durable as well, not afraid of chafing on these. A bit of common sense and these are super easy to use and install. Can only see black so works great, and finally protection is top notch!