Apollo 80-100 Series Bronze LP-Gas Ball Valve, Two Piece, Inline, Lever, NPT Female

Description

The Apollo 80-100 series two-piece inline LP-Gas ball valve is made of bronze and has a lever handle and female National Pipe Taper (NPT) threaded connections on both ends. The valve body is made of bronze for higher strength and corrosion resistance than brass and it has a zinc-plated steel lever handle with a vinyl sleeve for manual on/off control. This valve is listed with Underwriters Laboratory (UL) for safe use with liquefied petroleum gas (LP-Gas), natural gas, flammable liquids, and heated oils. The maximum pressure is 600 pounds per square inch (gauge) (psig) for water, oil, and gas (WOG) and 250 for liquefied petroleum gas (LP-Gas). The valve is inline for connecting two pipes going in the same direction and has NPT threads on both ends for creating tighter seals than straight threads. This ball valve has large ports to reduce drops in pressure and has reinforced polytetrafluoroethylene (RPTFE) seats and a PTFE seal to reduce the risk of valve leakage. This valve is for use with LP-Gas lines, water lines, processing plants, and agricultural applications and meets standard MSS SP-110 for quality assurance. Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hole of the ball is the same size as the inner diameter of the connecting pipeline (resulting in lower friction) and is reduced port if the hole of the valve is one pipe size smaller than the pipe, resulting in less flow through the valve than through the shaft of the pipe. Ball valves may have a handle or lever that aligns with the ball’s position (open or closed) for manual operation. They are primarily used in air, gas, liquid, and steam applications. Apollo manufactures ball, mixing, and relief valves, actuators, water gauges, marine fittings, heating and plumbing products, and backflow prevention devices. The company, founded in 1928 and headquartered in Matthews, NC, meets International Organization for Standardization ISO/IEC 17025:2005 and makes products that meet ISO and American National Standards Institute (ANSI) standards.