SOLED OUTCleanSole Pro (x2 sheets, for Contouring Soles) Protector for Sneakers, High Value Dress Shoes, Heels. Easy to Apply Peel-And-Stick Adhesive Film to Shield, keep Footwear Soles Clean & Scuff-Free

If you follow the instructions, and use a heat gun to make sure all parts of the shoe are covered with no gaps, these will last for awhile. While applying these, I did it in sections and used my fingers to apply pressure while holding the shoe up to light to make sure there are no gaps between the shoe and shield.I've walked in gravel multiple times with these and they didn't budge or get damaged. Highly recommend! I've tried other brands and they feel off after first use.

This is the 2nd pair I bought. First one works fine with the Jumpman Jack pair but failed on this Travis low. Exact steps of applying but it did not just sticked well enough to stay

I applied these on my daily white sneakers. The installation instructions are pretty clear and as long as you follow the instructions, it will stay on. I've worn my daily white sneakers with these on for about a week and they are still going strong. There is a bit of wear where my shoes usually wear out first like the outside heel and one part of the toe, but there is plenty of this left still. It has rained and snowed and while I didn't go into deep snow, I've had to walk on it and the sole protector still stayed on perfectly fine.For those that say they fall off, you either have really weird shaped sole shoes or did not follow instructions and properly prepped the surface before installing and/or wore the shoes too early before the adhesive had time to actually cure.Get these if you want to protect your sneakers and delay the wear AND FOLLOW THE INSTRUCTIONS!

Can adhere to the soles well a lot easier if done with a heat gun however found it a lot more difficult than other brands I’ve purchased in the past

Highly recommended

Great product for protecting the soles of your shoes and keeping them new as the day you buy and with heat added it conforms to the ridges and design of the sole

Product does not adhere in crepe outsoles even if you follow the instructions carefully. Sadly, the listing, does not specify that. After the installation, the sticker didn’t last 30 minutes on a sunny day. Be aware!

Now I haven't had a chance to put these to use yet. When I do I will update my review. But as far as installation is concerned. It really couldn't have been easier. But before you purchase these... YOU MUST HAVE ACCESS TO A HEAT GUN! If you don't then don't bother. Seriously! They won't seem sticky at 1st but once you slowly and evenly add heat they will fall right into place. You'll have to push the edges down after the bottom and apply more heat. A HAIRDRYER WILL NOT DO. I used a Makita heat gun and had it turned up 1 notch before max. Be careful and take your time. If you stick it to the shoe wrong at 1st. Lift off start over. It won't affect it all.