Hatchlift ENDF-10-QREL 10mm Quick Release End-Fitting

The fittings on my heavy truck bed cover were in bad shape and I was always afraid they would pop off! And one of the spring clips was missing. These 10mm Quick Release End-Fittings fit perfectly on the ball studs and I'm no longer afraid they will come off! The bed cover works like new again! Releasing them takes just seconds to do! Very happy with my purchase!

Couldn’t get from specialty truck store. Easy install. Have two for backup. Price ok.

The quick release that was on my new tonneau cover didn’t work very well and were extremely difficult to “push” into place. My thumb would always hurt with the amount of pressure I’d have to exert. The slide open easily allowing me to remove from my support bar when flipping up my tonneau cover. I wasn’t positive if they would fit but it was a perfect match.

The factory end of my tonneau cover strut was damaged. The strut kept popping off. Replace the damaged end with one of these new pieces and I am back in business. Couldn't be happier!

Switched these out on a prop for my RV door, allows me to remove completely to open the door wide to allow stairs to swing up/down

I installed the end fitting in 5 minutes.

I had some decent 10" gas struts for a small trailer but the threads stripped out on one of the ends of the composite fittings. I purchased these because they appeared to have a brass metal thread inside instead of a composite thread. They did and I just upped the ante of these gas struts. Very easy to remove and place on 10mm post too.

What tends to break on bed cover struts is the connectors - and these fill the bill. So far, they've held up better than the originals - and considerably less cost than the whole strut. I am so glad I stumbled into these. Simply screw the old one off, screw the new one on and you're in business!