HIKARI PAIR LED Conversion Kit Headlight Canbus Error Free Anti Flickering Resistor Decoder - H11

Fixed flickering of LEDs when car was off. Highly recommend.

Just wanted to let everyone know about this product. I used them on a 2015 volvo s60 with beamtech led h11 lights. Wanted to clear up a lot of negative reviews here. When connecting the wire harness clips they can go together many different ways. First plug them in if it doesn't work reverse they connection where the bulb plugs in by rotating the harness 180 degrees and plugging back in. If it still doesn't work rotate the harness 180 degrees on the clip coming off the car. One more if that doesn't work rotate 180 the clip where the bulb connects. You have like 4 different options by rotating the clip around. Im sure most people leaving bad reviews just plugged it in once and said this doesn't work. Play around a bit till you get it. Volvo is one of the most difficult vehicles along with mopar to eliminate dash light and this product works on both.It really works so give it a shot!!!!Thanks Ryan

These are a must have for the H11 LED bulbs to work in a 2013 Ford Escape. I would give five stars, but the resistor pack is too large to fit into the back of the headlamp assembly. Double sided adhesive tape is needed to mount it to the inside of the fender. Other than that, the lights and decoder work great.

Finally found a kit that works on the 2013 Focus. 0 error codes!

I bought them for my 2006 Volvo s40 because I just installed some led headlights and was getting a bulb failure dash message. After installing them correctly, not only did they not fix the warning light, it made the light flash inconsistently, completely blocking out any other function on the little message board. So I'm going to return these and try a different brand. Also, these were used with Aukee h11 led headlight bulbs.

Installation was easy. But they didn't work for my vehicle. My dashboard kept showing low beam failure. 2017 Volvo V 60 T5 with all digital dashboard. The LED'S worked, but this product made my dashboard angry.

i installed these on a 2018 Dodge Ram. Easy connection to the Hikari bulbs. I tested the connection before reinstalling the light assembly. On the drivers side, I did have to flip the switch over and boom, light on. There are no dashboard messages and the lights work exactly like factory. I put interior dial to auto and everything works perfect

Installed LED low beams on a 2013 Ford Focus and started getting a low beam error message and then the headlights would shut off. Ordered this and have not had a single issue since. You may need to flip the connectors around to get the polarity right as they install both ways, but just don't reinstall the headlights until you have tested them and it's no issue. Overall would recommend.

Works as described, previous to install. I had a hyper blink, and sometimes the lights would turn off . After installing the lights work perfectly, no issues!!!

Fonctionne pour ma voiture mais la lumière clignote encore un peu

These do not work in a 2013 Ford focus.

The connectors on this item are not coded/keyed so will connect in one of 2 positions each. So if the lights don’t work at first just try flipping the connections one at a time. After that they work and no light check warnings

I have installed it on ford focus 2012, sometimes I am still getting headlight fault, but after couple of engine starts lights finaly stay on. Happening not too often so I decided to keep it.Quite big but I was able to fit it inside including module of led bulb, without any modifications