AMZCNC Hydraulic Gear Puller 5 Ton Max. Capacity Hydraulic Puller 2 or 3 Jaws Bearing Hub Separator,Hydraulic Puller Separator Tool for Pulling Hubs, Flanges, Gears, Bearings (5Ton 8" jaw)

Works suprisingly well. Seperated a rusty cv shaft on an escape out of a hub without needing heat or new hub bearing. Everyone knows those ford cv shafts suck.

This hydraulic gear puller will definitely do the job. Very fast, and easy . A bit heavy but that’s to be expected from a heavy duty puller. Easy to assemble and disassemble.

Depending on what you are removing you may need to make a rigging to attach to. But, works as advertised, was able to pull a wheel off a car with no effort. Is heavy duty, and has some mass.

Has helped me in so many ways. I was tired of beating items apart, and this has made thing move like butter!

Serves it's purpose, but arms bent the first time I used it. I had to hammer it back into shape several times to remove the other rotors.

I was unable to remove a seized propeller off a mud motor hex shaft. We tried penetrating oil, heat from a propane torch, striking it with a rubber mallet and tapping it with a hammer. I also tried pulling it off with a bearing splitter behind the prop and a four ton mechanical gear puller which broke under pressure without budging the prop. Finally in desperation I ordered the AMZCNC 15 Ton gear puller. We placed a large bearing splitter behind the prop again so we had someting to hook the gear puller legs to and started pumping. After a few pumps of the hydaulic handle the prop popped loose and we were able to remove it. I highly recomend this tool as it is very well made, comes in a hard plastic storage/carrying case and it gets the job done.

I was disappointed the first two times I used it as I spent more time putting it together than actually pulling the fan hub I was working on. Third time I used it, I got called in by a guy who just broke a traditional puller. This bad boy pulled that 4” sweat on hub fairly easily. It was getting to where I needed to out some force on the handle to pump it, but it got it done.Jaws are really heavy, so no issues there. Fairly certain the bolts would fail before the jaws.This thing is a monster and I love it.

I bent an old puller I had trying to remove a stubborn CV axle. This thing pushed it right through with ease. Very happy with it..