RoyPow12V Battery Charger 10 amp LiFePO4 Lithium Battery Maintainer, Automotive Trickle Charger with Alligator Clamp and Ring Terminal

Very simple charger that works exactly as advertised. It is only 3 amps, so it might take a while to charge depending on the size of your battery. I am using this on a 100 Ah battery, so it takes about 35 hours to go from 0 to 100%. If you need a fast charge, you'll want more amps, but I am in no hurry, so this is a very gentle charging pace that works. It has two LED indicators. One green LED is on when it is plugged in. The other LED is green when the battery is fully charged and red when it is charging. That's it. It is quite small and is easily held in a hand. It does get warm when charging but not hot, though warm enough that you wouldn't want to hold it in your hand and squeeze tightly for too long. Once the battery is fully charged it just waits until the battery voltage falls and then it will bring it back up to 100%. For long term storage of LiFePO4 batteries, the usual recommendation is to store it with about a 40% charge. But I use mine for unexpected power outages, so indeed I want it charged and ready to go because outages are rarely scheduled. I am quite happy with it and see no need to get a larger unit. If I was cycling through batteries daily or more often, indeed this would be too small, but for how I use it, it is just fine. No fan so no noise.

Got this 3A model to replace a different 1A model being used to charge the starter from my aux power for multiple purpose/reasons. Even smaller and more convenient wiring/storage than the one it replaces. Comparing to other reviews it doesnt seem to get too hot. Good purchase so far.

charges batteries well, gets really hot but some PC fans keep the temps down. the charging end has an SAE connector, so if the included 6M ring terminals don't fit your need them you can just a separate harness, or use the included clamps. just remember to get a fan to cool it down as it gets too hot to touch during charging.

Just what I needed.My current 10amp red LiFePO charger with a fan (I'm sure you've seen the likes) causes my robot's electronics to freak out with its noisy charging. So far, this charger allows me to use the robot's system's while it's charging. It also has no fan to get gunked up when the robot is outside in nature. It does get warm.

I tested this it passed

I Bought 2 for 12 v lithium deep cell batteries. They work great and charge really fast. Very happy. I use them for my 2V 12Ah LiFePO4 Batteries that I use for my shrimp lights.

- the output is 13.8v, NOT 14.4. That means it will charge the battery partially.- after it passes 13.1v on the battery, the charging power drops to 4-5A.- it get extremely hot. You will burn yourself if you touch it. It needs to be supervised continuously while charging to avoid fire or damage.Strongle recommend against it

Fácil de usar