Black Powder Revolver Loading Stand - Fits .36 & .44 Caliber - MZ1213

Well built and easy to use design...loads in seconds

Easily converts between calibers. Easily centers the plunger over the cylinder chambers. It's best to hold the plunger straight with the left hand when pushing the wad and ball down into each chamber. The plastic arbor to adapt the center pin for larger central hole cylinders fits colt revolvers nicely. Great product overall.

Ok, took a chance. Thought given the generic description I could sneak one by. I mean reloading stand for 36 and 44 should work for 45, right? Nope!!!!!!!!! Cylinder spud is too large. Otherwise its construction is somewhere between a 3 and a 4 star evaluation and I went against prejudice and gave it four stars. It’s not a total loss since I have 36 caliber BP revolvers. Still construction could be a little beefier but I bet some of the looseness is intended given its “universal” uses. Now if they designed this with different cylinder spuds and a quick way to change out, I would charge $3.50 more and rate it five stars.

Like black powder revolvers. Works for 36 cal and some 44. Not Lemat that I am aware may be wrong and not for walker unless using it wrong

I gave it a 3 for the fact that it had two 44 cal plunges and no 36 as described. Otherwise it seems like it will work fine. Base is a little on the light side so will probably have to mount it to something a little heavier.

smaller than i thought but still a quality, good loading stand and has the sleeves for different calibers. a solid choice and should last

gets the job done. good stable stand for reloading the cylinder outside of the revolver frame.

Bottom line is it works, but not well. Since it is designed for different revolvers, that means it is not an exact fit for any. Like I said, it works, but the geometry is off. I modified mine in order to align the plunger with the cylinder better. I will probably use some of the parts and just make another one.