Rough Country Cold Air Intake for 1997-2006 Jeep Wrangler TJ | 6CYL/4.0L - 10553

Many complain the rubber fitting doesn’t fit between throttle body and intake tube …well it does, it’s tight the way it should be.See picture.The two hose clamps shipped with the kit? You will only use one on the intake tube. The one on the TB you need to remove and reuse the one off your old intake tube. The one shipped it too big.Also the angle bracket that is suppose to mount on the fan shroud wasn’t even close to fitting. Maybe 1997 TJ’s are different than later years I had to grab two fender washers and mount using the open hole above the suggested mount point on the right hand rad support.Nice sound overall I’m satisfied with my purchase.

Definitely increased air flow over stock system. Sounds pretty good, as well. Nice little whistle in the 2-2500rpm range. Paired with a throttle body spacer as well and there is a much better throttle response. Good set up for the money.

These are easy to install and look like they're specific to the vehicle. Have one (different model) on my Gladiator and bought one to give a little angry to a classic TJ in the driveway. I didn't install on the TJ ultimately but for good reason. The most you'll notice it is on rev under load, like when you speed up to pass someone For that reason, and that reason only, I thought the TJ may be a bad idea. My youngest just started driving, the TJ is her go to vehicle and I didn't want her to have a reason to jump on the throttle. If you're an adult and just want that angry rumble off the line, go for it. You won't go wrong with this one.

Seemed like a box of thrown together parts. Main in components “fit” made it work. Does what it's supposed too. Satisfied with better performance.

Plenty listed issues/troubles in other reviews. I had to address nearly all of these myself, so i will list how i fixed things and have pictures to show as well.1. Rubber coupler hard to slide on - Yes! However, simple solution is to run it under hot water for about 30 seconds till it gets pliable and it will slide right on.2. Intake/throttle body angles are extreme - Yes! Solution: line up coupler on Throttle Body and mark the angle- i used a sharpie, then use a razor knife to cut an angle into the coupler and remove unneeded material to fit the angle better. Do this once its on the pipe.3. The supplied hose clamps will not tighten down enough for the connection at the throttle body - simple fix with an aftermarket hose clamp.Besides those small issues....this install took me less than 30 minutes- i already had old air box and battery out.Hope this review helps future buyers.