Dokili 100-9068 Replaces Toro Electric Blower Vac Impeller Fan 98-3150

Needed a discontinued impeller for my Toro Leaf Blower 51570. Old one had 11 blades, this one has 9, but it works great!

Fan is a NEW casting of your old fan. New castings have rough edges. I used sandpaper to even the blade edges. However, the center hole cannot be fitted without a small rasp/file to remove the rough and allow fitting onto the motor. Do Not try to force-fit the 300 MPH fan ! Works perfect, more quiet & smooth than the old fan.

The second time I used my blower after installing this part it shattered. That alone would not have been so bad but the pieces blew a hole in the housing of the blower ruining it completely. Now I need to buy an entire new blower/vac.

Easy to replace...

Mounting hole in the impeller is too small to fit onto the motor shaft. I had to make the hole larger with folded sandpaper and grease the shaft to press impeller into place. It worked fine after modification.

I replaced 2 impellers. great improvement for blowing. Price was great but already broke one using it as a vac/ mulcher. Will need to get sturdier ones to do both.

I can't believe it. I just bought my Toro leaf blower in 2002 and the impeller broke already! This Dokili brand replacement was less than half the price of the OEM piece so I took a chance. Like other reviewers I found that the center hole was too small for the shaft. The rectangular hole is too small in width but the length is OK. Don't bother trying to file it out - it will take forever. Instead, use a 13/64" drill bit (the next size over 3/16" in a good set of bits) to drill two holes side-by-side. Slide the impeller back and forth on the rotating bit to clean up the hole. It should fit on the shaft perfectly after that.

It works well, but in order for it to fit on the motor shaft, I had to file out the hole first. It took about 20 minutes of trying with jewelers' files.

livraison très rapide et article conforme a la description.