TOOLDO3" inch Bearing Flush Trim Bit，C3 Carbide Flush Trim Router Bit, 1/2 inch Shank for Wood Router, for DIY, Woodworking Project, High Grade

I used the bit to router out a sink that was made out of two-inch butcher block. It done just what I needed it to do. Thanks.

I made an end grain oak checker table with a resin too and bottom. The edges were a mess so I got this but to clean it up. Wow what a great job! I would put a pic but don’t want to give Amazon access to my pics. Highly recommend this but!

works well, I am not sure of the longevity. I just received it last week and have only used it once. I like it.

As SEVERAL OTHERS saying here, this is very defective, used it for one cut and the piece shattered all over the place. Norm Abrams, thanks for reminding about safety goggles. Literally almost put an eye out. Thank heavens he had them on!

Like many have said on here, the bit itself is a great bit for the money and has held up well, but do yourself a favor and put a new 1/2" bearing on it. Even though many reviews said the bearing was bad, I decided to try for myself and after about 30 seconds of use the top plate came off the bearing and it failed. New bearing on it and it works just fine.

I had been looking for a flush trim bit this size for a while now. This is it! Was able to flush trim 2.25" slabs of 3 layer .75" plywood glued together with ease! Plenty sharp and bearing is solid! Totally happy with my purchase! 10/10 would recommend to others!

Worked well and cut with minimal issues

Bearings blew up immediately, knives are horrible, terrible garbage. In 25 years of making furniture this is the only router bit I've cussed out lol junk !