Kaka Industrial AP-1/2 Arbor Press, 0.5 Ton Cast Iron Arbor Press, 3" Height Leverage Arbor Press, Heavy Duty Arbor Press, Manual Desktop Arbor Press Cast Iron Material, for Riveting Punching Holes

Works really well for me.. the ram portion even goes around 1/8" below the surface to ensure stuff gets pushed through .. very wide back piece.. -you may want to lube up the mechanical pieces and bolt to a solid table

I knew there would be some light assembly involved, but I didn’t expect to have to do it without any instructions. The press only comes with an “assembly diagram”, which isn’t helpful at all, because by logic, I already knew where the parts went.The gear comes with a sleeve (ring), which you have to remove, otherwise the gear won’t fit into the chamber. This ring will later secure the gear into place. See attached pictures for reference.I evidently was able to figure out what to do, but it would have been nice to have instructions. Also if you’re a complete noob like me, beware that you’ll need tools - an Allen/hex key set and a wrench to be exact - which don’t come included.

This is my second one, first one was fantastic, not sure how this could happen on the second unit, press arrived with rust everywhere, unit keeps seizing, just awful.

The press works fine now after plenty of WD40 and manual clean up. I will have to buy some grease and get it on there to keep from additional rusting. Couldn’t even move the handle and had to be sprayed and worked up and dow.for about 15 minutes to get it mostly freed up and moving smoothly. Probably wouldn’t buy again

I needed a small Arbor press for my FPV drone hobby, primarily for pushing press nuts into carbon fibre, and for removing and installing small motor bearings. This press does the job really well and is compact enough for me to be able to stow it away when not in use. I recommend it.