This ingenious screw design replaces the milspec factory grip screw to remove the trigger creep and travel from factory mil-spec triggers. The kit comes with an adjustment screw, lock washer and wrench. The adjustment screw allows for tweaking the hammer and trigger engagement points to clean up the GI trigger and give you a cleaner trigger pull for increased accuracy. This is truly the poor mans trigger job. INSTRUCTIONS 1. The internal set screw comes with thread locker pre-applied but for best results remove the internal screw and apply additional thread locker and re install the set screw inside the large screw. Make sure to screw down the internal screw all the way in so that the tip just protrudes. 2. Remove the factory grip screw and lock washer from the grip of your rifle. Mind the spring and detent for the safety as they may bounce out if you remove the grip completely. 3. With the hammer cocked and the gun on safe, insert the Trigger Adjustment Screw into the grip and tighten the large screw with a 3/16" hex wrench until he pistol grip is secure. 4. Using the included hex wrench, finger tighten the internal screw inside the 3/16" screw until the it stops. DO NOT OVER TIGHTEN. Backout the internal screw 1/4 turn at a time until the safety lever can by actuated. Verify that the trigger, disconnector, hammer and safety function correctly. Let your additional thread locker dry before putting your rifle to use.
Trustpilot
2 weeks ago
1 day ago
