PET Expandable Braided Sleeving 25Ft-1/4 inch Wire Loom, Aibole Braided Cable Sleeve Wire Wrap,Black&Red

First time using this product. It was a little tricky at first but worked out great.

This cable wrap works like a Chinese finger puzzle: if you pull on it, it gets tighter. So, to run cables through it, they need to be pushed. Once a cable is all the way through, it is very difficult to add one. So, I found the best approach is to send them through one right after the other: as soon as the end plug of one is through, send the end plug of the next. repeat until all intended cables are inside and then finger-puzzle them through. I created a couple of 15' custom cable harnesses with this sleeving. It definitely cleans up the cable runs. As others pointed out, you need to melt the end where you cut it to prevent it from unravelling. I also set the ends with cable ties to make sure they didn't unravel over time from use/abuse.

Super happy with how this came out, used it on many different projects, always looks professional

This is really nice once on but a little hard to use as the end unravels when feeding the wire through it. After putting on a ring of heat shrink and hitting it with the heat gun it looks good. I'm getting better with practice and likely would buy again.

Built this amp rack for a friend because he got a larger amp. He wanted near wire management so he asked me to do it for him. This was my first amp rack ever. He wanted all of the power lines wrapped and this stuff is amazing! I would suggest after each cut from the roll, you use a lighter to burn each end to help keep the pattern together and not have it fray on you. Will definitely buy more in the future.

Item as described

Wrapped very tightly and flatly on the reel. Advertised as being split, but I don't see that it's split, so I'm not sure how easy this is going to be to work with. I purchased the blue and black bc of the ratio of footage:$$. It does seem to be made of a tough material. We will see how it goes.

First of all, it is not the split type. It is not difficult to work with and it constricts around wires very nicely. PE hen using it reminded me of Chinese finger cuffs. Use hot scissors to cut like butter with no frayed ends. I heated the scissors with a torch style lighter before each cut. If you use this method leave the scissors open after the cut or the residue plastic will stick the scissors closed. A little heat will get them free for the next cut. I would buy again.

This doesn't fit over a standard RJ45 plug without ripping and fraying. Works good if you sleeve the cable before crimping though.

Use this stuff lots. Great for protecting wire exposed to any possible abrasion. Trailers, tractors, etc. Expands to accommodate install, connector size change etc. recommend, I use a lot so a roll is nice

Basically a giant Chinese finger trap. I understand it is supposed to heat shrink, but you risk damaging your cords if you heat it enough to prevent fraying, and no matter where you heat it, it is inconvenient. Maybe I am wrong, but there are no instructions to tell me otherwise. Would be 1000x better if it came with some kind of sealer or clasp for the trimmed ends, or with just basic instructions.

Worth it.

The wrap does the job but is much thinner than it's industrial version.Only issue I had was that after it's been cut it quickly turns into loose strands.When heating the end to melt the strands together in an effort to avoid them unwinding, the strands become a lump of plastic very quickly due to them being so small.Not a bad product but I'd look for the heavier duty option in the future.