⚙️ Drive Your Innovations with Power!
The WMYCONGCONG MOSFET Driver Module is a high-performance solution designed for PWM adjustments in power MOS tubes, compatible with Arduino and ideal for 3D printing applications. With an output voltage range of 0-24V and a maximum load current of 5A, this compact 10-piece set ensures you have the tools needed for efficient and effective project execution.
| Manufacturer | WGCD |
| Part number | WGCD 1 |
| Item Weight | 96 g |
| Package Dimensions | 19.2 x 14.2 x 4 cm; 96 Grams |
| Manufacturer reference | WGCD 1 |
| Size | 10 Piece |
| Item Package Quantity | 1 |
| Batteries included? | No |
| Batteries Required? | No |
T**C
It's just a MOSFET on a PCB
You might as well just buy an IRF540 which are about $1 each from any component supplier, and your guaranteed the right product. They don't even have an optocoupler so they are not an isolated solid state switch. Essentially almost the bare MOSFET.
M**.
Great to have some on hand
I've used these for a few projects to connect to ESP8266 modules. I have them acting as remote switches for various things or PWM to control LED lighting intensity. I could have simply gone with a bare MOSFET and soldered connections, but the screw terminals make it easier and the labelling is helpful.
H**H
Hervorragend zum Ansteuern von LED-Streifen
Ich hatte noch einige Meter Verschnitt von Philipps Hue Lichtstreifen, die ich testweise mit einem Arduino Nano ansteuere. Entgegen der Befürchtungen anderer Anwender konnte ich keine Aussetzer erkennen. Die PWM-Ausgänge des Nano geben knapp 5 V aus und schalten die MOSFETs soweit ich das sehen und messen kann sauber durch.
G**P
The easiest way to add control to an Arduino (or any) project.
I like that I don't have to solder up the MOSFET or other connections. Signal connections are made through the standard "Dupont" header hookup wires. Power and Load connections are through screw headers which seem to be working fine. There is a tiny red LED which lights up when the signal is active (helpful for troubleshooting), and the whole board seems to be pretty robust.Heck, they are about a buck each and will handle loads of up to 5A at 24VDC, I think it's a bargain to not have to do more wiring than you have to.
T**X
I hope you don't need all of them
A few were broken.
U**.
Finger weg wenn an Arduino, Raspi oder ESP
Habe immer mal wieder solche Module gekauft und in Verwendung. Diese hier müssen jedoch mit mindestens 6Volt angesteuert werden um zuverlässig durchzuschalten. Somit leider unbrauchbar und zurück an Amazon
Trustpilot
2 days ago
5 days ago