X3 Super Extended Fender Flares For All Can Am Maverick X3 Models 2017-2021 Include MAX(6 Piece Complete Set)

Look great, fit well once you figure them out. Took a little while to figure out the install as the instructions were a little lacking. Can-Am actually has dimples at each location, however watch because these fender flares do not utilize the bottom factory screw location. I now have an extra hole in the plastic, my own fault. Note they can be a little finicky in getting them to fit. The plastic needs to be pushed and moved, but overall they look great when done and actually fit well.

Just got these installed and it was pretty easy. I did not have pre-drilled holes on the very bottom piece and didn't have a 90-degree drill on hand. I was able to get 2 of them with a drill so once you do that you can gauge where the other 3 screws need to go. I used a regular sized drill so if you have a smaller one you may get to the others or just hope you get the screws into the secured piece in the back. Everything else was pre drilled. You really don't need instruction just look at the picture in the ad and you can see where they go. They only go one way. I read some folks said the bolts were rusting. I should have put some anti rust but I live in the desert so I'm not to concerned I may have them powder coated to match the SXS. Other than that I love it. 5 stars baby!!!!

If this are not the OEM they are just as good in strength, fitment and looks. Installation can not be simpler.One piece of advise, pre-drill the holes in your SxS instead of trying to drill with the screws.

Easy-to-use, had it done in 20 minutes easily done. I recommend finding the marked holes and running at least the tip of the screw first threw all of them and the line them all up and screw on enough to hold the piece on there, and then once they all are on tighten down there is the bolts on each side of the rear fenders and your done. You will absolutely love how they look it makes it look like a totally different machine, pictures dont do justice in person its even better. I would recommend these to any of my friends or anyone interested in this product the kit comes with all the necessary hardware to tackle this easy to do project, also well protected when it comes to packaging it is dummy proof!

Once I figured out how to install them they looked great. Lines up perfectly with the pre-indicated holes. There are no nuts included to match with the bolts for the rear fenders. But I can always get some at the hardware store. I cannot tell if they are meant to be included as there is no actual parts list included. The installation instructions are photocopied and therefore not easy to read. I’ve included a picture for reference. Not a huge deal but really no excuse in this day and age to have poor photocopies. I would totally buy it again. Wish they came in different colors!

Oem quality for a fraction of the cost. My only issue is the coating is coming off the nuts and bolts on the back underside and are rusting. These should be ss hardware. Other than that its an overall great buy.

Great value excellent fit like factory drill the dimples use screws providedCan am planed it well dill dimples but double check the clearance behind where screws go (see photo)Bought them do to my new glass windshield had three close calls hopefully these will mitigate rocks flying upWishing they stuck out a bit further but Have mud flaps on the wayOut here in Parker AZ lot’s of wash’s are loose gravel and ROCKSLooks just like factory

Easy to install just as prommised. Instructions are no good. You will get alot of torque screws and 8 Ellen style screw with 6 washer and nuts. The 6 washer and nuts go in the rear the can am has 3 pre dilled holes if you look up un the rear fender. The other two gonin the fron one but you should already have a bolt their if its missing use the one provided. Other than that pretty easy. The other screws just go in.