WaterWarden Inground Pool Safety Cover 18’ x 36’ with Center End Step, 15-Year Warranty, UL Classified to ASTM F1346, Triple Stitched for MAX Strength, Abrasion Resistant, Hardware Included, Blue Mesh

Cover is thick without being overly heavy, appears it will withstand the ravages of time. Reinforcements under the straps to mitigate wear due to chafing. Straps, buckles, brass anchors all very good quality. Zero issues with installation. I used diamond 3/4" hole saw which cut through the marble pavers like hot knife through butter https://www.amazon.com/dp/B0B6FBXYF9?ref=ppx_yo2ov_dt_b_product_details&th=1. Lost my decking on one side in hurricane Ian - so used earth anchors also https://www.amazon.com/dp/B0BFFBZLRZ?psc=1&ref=ppx_yo2ov_dt_b_product_details and wall anchors on the back wall https://www.amazon.com/dp/B09S53WH25?psc=1&ref=ppx_yo2ov_dt_b_product_details.

Great price , quality not as good as the one it’s replacing but should be fine. I was concerned with several areas that the material was worn (see photo). I hope this doesn’t become a problem. I did reach out to customer service but no reply. In my opinion the drain is running the wrong way, but maybe there’s a reason it’s made that way.Install to me was not that difficult. Take your time and make sure you have a quality hammer drill and bit. I do have two small puddles every time it rains on either side of the drain. I’ll try and adjust the cover to rectify this problem.In the end I’m happy with the cover and the install.

I had bought a safety cover maybe 15 years ago and needed to replace it because it was worn and some field mice chewed a hole in it. The old cover did not block the sun and let the water through it. When I opened the pool in the spring I would have some algae and dirt at the bottom of the pool. I decided to try a solid cover to see if it would help. In the picture of the new pool cover it had the screen down the middle to let the water through so I didn't need a pump. It was a little disappointing that the screen was a square patch in the center of the pull rather than centered in 2 squares. I had to spend extra time adjusting the tension on the springs so the cover would sag in the center. I still couldn't get it adjusted correctly and I needed to play with the cover to get the water go into the middle square. If the screen was down the middle like they showed in the picture it probably wouldn't be a problem. I suppose I can't complain I didn't spend a lot of money for it and it actually matched the old anchors, saving me time.

I really liked how fast it shipped and the cover quality, same as installers bring at $6K, 100% suggested.However, the clips are like a 1965 belt slip design, need to be the lock type, like on the $6K type, this would have made it brilliant.Plus one last note with the clips being poor, still missing two.Lucky the installer had a bag of the fancy type and he is giving those to me this week.

This pool cover did not come with enough little rings to thread the nylon straps through. Several of the ones it came with bent. The spring mechanisms are very hard to use. The entire thing dropped down into our pool and there is now water standing on top of it, with lots of leaves. It will be a nightmare to clean when we take it off. I seriously regret this purchase.

I am so relieved that I got a safe cover for my pool because with a new puppy and 12 grandkids I can relax that my babies are safe.

The first pic is what our pool looked like with the old cover - water filled tubes to cover the walk-in steps, constantly pumping off filthy water and debris, frogs laying eggs and more frogs hatching, and when ice would form and thaw it would rub against the cover and cut holes. It was difficult to put on and horrible to take off, and then it was a two-day process of cleaning, drying and putting it away. The second pic is our new cover, and it's unbelievably wonderful. First, the best quality. Second, so so easy to install and if you'll notice we only have patio on three sides so we drilled into the cement on the open side and extended the straps out and anchored them into the cement on the ground. We've had several horrible storms and it didn't move, whereas our old cover was constantly blowing up and coming off the pool. I can't say enough about the quality or the material and hardware. As I said, best purchase EVER.

This is a very nice and well made cover. I was nervous installing the anchors by drilling in my concrete, but watched some YouTube videos, went to Harbor Freight and bought a $39 hammer drill and bits and installed it in one afternoon like a pro!! Highly recommend!! ( tip: drill 3/16” pilot holes and the 3/4” will follow them nicely and not “dance” on you. Also vacuum out your drill dust before installing anchors.)

Producto súmamente útil si lo que quieres es cubrir tu alberca de cualquier residuo externo que pudiera ensuciarla mientras estás ausente. El único pero es que es un poco complejo retirar los resortes cuando están en tensión, aún con la herramienta que viene incluida. Pero cumple su función y a un muy buen precio. Recomendada

Quality of cover and fastening hardware appears to be excellent.I took a chance ordering a cover meant for a 16'x40' pool for my 17'x41' pool (includes 6 inches of plastic coping all around the pool).The actual size of the cover for a 16x40 pool is 18x42. Fingers crossed when the Ottawa, Canada often deep winter snow arrives.

Was fairly easy to install, did it alone in a few hours. Looks great feels sturdy, would give 5 stars but have to see how it handles winter first.

The product is a good product. We did have to purchase a new drill bit to match the size of the brass clips. We wish we could have thought to get a longer product that would have covered our stairs into the pool. We just measured the pool and purchased the cover to match.

Hard to find size so I was thankful that it was available. Easy to install