Westinghouse6783500 Traditional One-Light Outdoor Wall Fixture, White Finish, White Glass Lens

Install was easy and they are made sturdy. Should last a long time.

Matched my existing fixtures nicely, well made.

Came quickly. Made well. Installed easily

Overall, the fixture is well made. Beware though, you need to use a Philips Screwdriver to remove fixture cover (a drill or driver with screw bit WILL strip threads. The fixture seats with a single threaded rod and cap nut like any light; however, affixing to a smooth plastic trim board allows for movement. Solve this problem by drilling a hole opposite the led circuit board ( behind the globe) and insert a #8-2.5” screw securing into trim. Use a dab of caulk to water proof if desired.

I've been a licensed electrician for over 38 years, these are as well built and designed as most fixtures I've installed. There are some bad reviews but I have no idea if the reviewers were from the electrical field or their level of DIY but I'm suspect on their level of expertise.

I use this is a back up emergency light fixture - 12-30 vdc bulbs and battery packs to power the buib mounted on wall with DC power wiring - really lights up the room and flush mounts.

This low priced light is all aluminum with a glass dome, unlike others in this price range with plastic frames and domes. Works great, and comes with installation hardware

It does work and it looks okay, but I was disappointed with the quality. The gaskets are made of a very cheap material and had excess that needed to be trimmed. There is a ring of weatherstrip tape on the inside backing that the glass and gasket rest on. It was applied haphazardly and leaves an inch or two with no contact. It is glued so it can't really be fixed.I was replacing an old standard porch light on the enclosed patio (aluminum surface) and was hoping this would be easy to install in it's place. This light is not designed for that. I needed to install it upright (not the horizontal option). I had two issues since it mounts from the middle, and it is designed to have a hole in the wall at the center. If installed upright, the top will either be about two inches above a typical porch light or you'll have to drill two new holes in the wall for the mounting bar. I didn't have room to spare so I had to drill new holes. Not a big deal, but something to consider. The real issue I had was the length of the nipple (the threaded tube that sticks out of the mounting hardware and through the base). It was too long when backed out as far as it could against the wall and the bulb was touching it. I could either a drill a hole into the aluminum wall to back it into, or cut it shorter. I cut about 1/4" off and it worked.One last thing to consider is the fact that when using a fluorescent or LED bulb, which have large bases, the light will be emanating from closer to the end of the glass where the lighted part of the bulb is. I think that makes it look little awkward.

A direct replacement for existing equipment. LED has the right colour temperature and should last longer

Easy to install, good price for LED, just metal is thin, hopefully they don’t rust out.

It’s a basic light. Not solar. Looks nice. Works well.

j'ai utiliser cette lumiere pour sauver de l'ectricité

Great value for the money. Good product. No complaints.