Fast Dealz Slotted Polymer Picatinny Rail Set For Handguards

Perfect for mounting lights , on my Mossberg , not sure I would truck a polymer rail for a scope set up . These are of good quality , and come with attachment hardware , Bolts and nuts are of good quality and you can torque them without damage . Use locktite or they will come loose .

Worked great on my lower hand guard on my DPMS ‘Oracle’ AR-15. Only had to remove a small corner of one of the oval Nuts w/a Dremel Tool so the shorter rail could be secured. Due to its short length & minimum space for both oval Nuts to be so close, the removal of a small corner of one nut allowed both oval Nuts to be tightened securing it rock solid. Had I elected to use the longer rail, no modification would have been necessary. I used the smaller rail so it wouldn’t interfere w/my grip when holding the hand guard while firing. Although not specifically made for the DPMS ‘Oracle’ factory hand guards, it worked! I would recommend & buy again!

I like the part that the the second screw hole is adjustable to fit the standard handguard (the one with holes on top and bottom). But you have to sand or trim the bottom edge to sit snug on the grooved surface of handguard. Then the nut that goes inside is too wide for the 2 smaller rail. It won't fit side by side then the aluminum heat deflector won't fit unless you do a different approach. Screw in the first nut then put the heat deflector then put the 2nd nut on top of the aluminum.

Purchased this item to attach bipod to Bushmaster AR15. Easy to install and weapon was balanced when aftermarket accessories had been mounted to weapon. Shipping was quick and product was packaged accordingly. Highly recommend!

Most of the predrilled mounting Holes DO NOT MATCH a Mil Spec MOE M4 handgrip! So you are limited where in the handgrip you mount this. The material is very good and looks nice, but mounting it is a PITA.

I ended up not using these rails on my AR, because I went with a different configuration after they arrived. Even still they are a quality product that will hold up just as well as the higher priced, individually sold products of the same size and material.

Who ever machined the screws and washer these needs to get a job at McDonalds or something. Holes are threaded smaller tan the screws. You can make it work BUT you shouldn't have to "make it work"", it should be ready !!!

nice easy add on the front cover of my AR15 and of course nice and cheap lol just use blue Loctite