Screw-on Rubber Cue Bumpers - 1-1/8 Inch

rubber bumpers were only 1" not 1-1/8". Used anyway.

Still trying to figure out what in the world bumpers my old cue uses, these didn't work, but I'm not gonna give a bad review for my bad research.

We have a large number of cue sticks, and several were missing the rubber end. Make a quick fix to put them back to rights.

Did the job but kind of cheap and on the hard side. There is not much to choose from for this product though.

I use these for the bottom of our kitchen table and a couple chairs so they don't slide around. They work perfectly and seem pretty good durability.

They worked perfect on my Brunswick pool cues.

Good replacement bumpers for our community center cues that get a lot of use. A touch of super glue besides using the screw to hold them on prevents rough use from tearing the bumper off the screw.

just as advertised. My old bumpers had a machine thread screw that I was able to use with the new bumper. I was also able to re-use my rubber plug that covered the screw after installation. This product showed up early, as advertised! 5 stars for sure!