12Vmonster DC 6V Universal Remote Control Wireless Switch and Receiver Set ON OFF Switch TOYS SMALL MOTORS Works With Any 6 Volt Or 12 Volt Duck Hunting Decoy Wiring Harness Included Easy Installation

I bought this item to install with my Baby Mojo Mallard Drake decoy...and it seems everyone else has as well. Here is how I installed this item.In my Baby Mojo there is a battery with the positive (red) and negative (black) terminals and wiring harness that is supposed to be used to easily plug in the Mojo remote system. Since we are all cheapskates we don't have a plug-in solution. The remote receiver unit has four wires...a positive (red), negative (black), and two yellow wires. I jammed the receiver in the space above the battery with all the wires sticking out the back so I could manipulate them. The red and black simply plug into the connectors that are already attached to the battery (assuming you plugged it in yourself, red in red, black in black). At this point you should see a red light in your receiver unit telling you it is powered. If you cannot get a tight fit, you might need to use electrical tape. The yellow wires I attached to each of the red connection points on the battery side of the harness. You have to jam is pretty far in to get a solid connection. Again, use tape if the connection is loose.Make sure the switch is off on the decoy and check the connection with the remote control. If it didn't work, you probably have a loose connection. I was able to use from at least 35 yards with the antenna still coiled up inside the decoy. Remember to unplug the receiver when not in use, otherwise you'll drain the battery.

I ordered two of these to try before I buy for all my motorized decoys. It took 7 days from date ordered until arrived at my house. I am now ordering for the rest of my decoys. I'll save you time searching for wiring instructions which were not included. Run red wire to 6V positive, run one of the yellow wires to 6V positive(doesn't matter which one), run black to negative, run 2nd yellow wire to motor. Basically you cut your 6V lead in half and wire red and yellow to battery side, 2nd yellow to motor side. I just finished wiring two of these and tested with decoys in my yard to inside house and remote worked great. The distance was same as I use in field so should be good.

As advertised. I learned, by mistake, that this unit will function on only 1.5v.(a single AA Battery) applied across the red and black wires. I attached an Ohm Meter across the two yellow wires while activating the wireless remote. On is closed circuit and off is open circuit.

I bought this to wire into my baby mojo decoy. The BABY Mojo a 6 volt system, the full size Mojo Decoy is a 12 volt system which will require a different system. If you can not find a 12 Volt remote system here, go to 12vmonster.com. With very little electronics experience, the receiver is very simple to wire in. However, there are no directions in the case. If you have questions about wiring into a decoy, there are several posted on the internet, or I would be happy to try to describe it replying to a question on this site. I tested the remote from 20 yards away, which is about the distance I place my decoy while hunting. It worked flawlessly. The only reason I am giving a 4 star rating is for the lack of directions. I love the remote system itself.

It works as advertised. It's a little confusing getting it wired correctly with no directions. One yellow wire needs a constant ground the other yellow wire interrupts the circuit. You need a multi meter to figure out which is which. Once it's wired up it works fine and has plenty of range.

I used these to make my Lucky Duck spinning wing decoy remote controlled. These come with no directions but YouTube has plenty of videos and I'll answer any questions you might have. Very straightforward design on these. Arrived sooner than estimated on Amazon.

The package I received did not look anything like the product image posted. In the description, it claims it is prewired to fit a mojo decoy wiring harness. There was no harness present. Just 2 yellow wires, one black wire, and one red wire. Heck the receiver was white instead of black. Then I had to watch a YouTube video on how to make the thing work. And not the video that they link to the qr code that's on the box. That video is almost useless. On the plus side, the range is about 100 yards. I just generally enjoy receiving the product that is advertised.

I purchased the remote to put on my MOJO Mallard. The wiring was no problem and getting remote to turn the decoy on was no problem. The problem I am having is getting it to turn off. I can turn the decoy on from 30 yards, but I have to be 1 foot from the dang thing to turn it off. The reason I bought this remote was to be able to turn the decoy off when geese are coming in. We all know how geese HATE mojos. If anybody has any ideas of what may be my problem, let me know. TIA

Funciona perfectamente y fácil de conectar

Does not work in all ducks. Could not wire to lucky duck junior. I attempted many wire set ups hurting the security of the wires on my new decoy. Save the pain and buy the lucky product.

Good replacement

Worked well on baby mojo

Works awesome with my Mojo Decoy.Saved over 60$ buying here than the big outdoor stores