DeepCool GAMMAXX GT CPU Air Cooler RGB Aura Sync 180w TDP 6mm x 4 Pure Copper Heat Pipes CPU Cooler with 120mm Fan PWM 1500RPM 56.5CFM for Intel LGA 1700/1200/1151/1150/1155 AMD AM5/AM4, Black

System info: Amd Ryzen 5 3600X, Asus TUF X570 mobo plus wifi, G.skill 32gb 3200mhz ram, WD sn750 1tb boot drive, SK Hynix Gold s31 1tb storage drive, Gigabyte geforce rtx 2070 super gaming oc 3x, Fractal Design Meshify C glass panel case.Got annoyed by the stock cooler that came with my cpu. It did the job, but that's pretty much the only positive thing about its performance. The Wraith Spire cooler always got stuck in this loud annoying feedback loop: Temperature rises past 45C, fan starts going into overdrive; temps fall down, fan slows and allows temp to rise again, thus starting what felt like a never ending cycle.I am pleased with this cooler's performance, noise, and aesthetics. The fan itself can be controlled via pwm, the speeds of which were far more flexible than the Wraith Spire for whatever reason. Idle temps are usually in the low 30s for me, with the fan being virtually noiseless under 50C. Load temps tend to hover just below 70C, occasionally crossing into and staying in the low 70s. The fan gets significantly louder at that point, but not what I would consider inhibitory towards concentration.Aesthetically, it's very pretty to look at and adds a nice pizzazz to a pc. Syncs well with my motherboard's native rgb control, cycling through colors to match the rest of the few rgb components I have installed. Only one color can be managed at a time though, at least for this model. I believe the newer addressable rgb version is a few dollars more, which Deepcool may eventually replace this model with.Installation was fairly easy, although there are a few points to watch out for. Contrary to the instructions provided by Asus, the native backplate of my motherboard needed to be removed in order to install the one included with the cooler. Also be careful to place the nuts provided into the appropriate backplate holes, as the "AMD" labelled hole is not, in fact, the same as the "AM4" hole. The brackets which hold the cooler in place also needed slight adjusting to match the hole alignment; you can very clearly slide the positions of the screws to do so. The wires are a bit too long imo, forcing me to hide them under the fan and behind the ram for the sake of good cable management. Obviously, some builds may require the length provided, so ymmv.Luckily, my case provided me access to the backside of my mobo, so installation was fairly straight forward aside from the few hiccups listed above. Can't really say anything about the inline controls provided since my build does not require it. Overall, this product is an excellent cooler with fantastic value at its $35 price point. Would recommend for midrange cpus.I'd add pictures to showcase the installation process, but amazon isn't letting me for whatever reason.

Being a long time fan of the Cooler Master Hyper 212 Evo CPU cooler, I was very excited when I seen this cooler listed for sale, so I picked it up quickly to test out on my AMD Ryzen 7 1800X.Being that not many companies are advertising that they work with AM4, this one includes everything IN THE BOX to mount right to your new AMD Ryzen CPUs and APUs, no additional hardware needed, so you can get right to cooling your chip with this cooler as soon as you open the box, and cool your chip? Yeah.. That's exactly what this CPU cooler does.I was using a ARCTIC Alpine 64 Plus which was keeping my system around 33℃ on idle and I would reach 80℃ degree temperatures under load, of course I rarely run my system under a full load, but did NOT like my CPU reaching those types of temperatures when I did.The packaging was very nice for the cooler, and included EVERYTHING needed to mount this CPU cooler, even included a small tube of thermal compound that I've been using on other CPUs as well, so that was a nice included bonus in the box.I was a bit skeptical when I seen the fan mounting system, but it works fantastic, you put the clip on, push it over fins and it's attached, could not be more simple.The RGB cables were also very nice and easy to hook up, I'm not a huge fan of the controller that is included, but if you have the right case, you could possibly mount it on the outside, but I say stick with Aura Sync for the RGB.The way they included a small notch in the CPU cooler to run the cables for the RGB plate that sits on the very top was very awesome, it's nice and hidden and out of the way from the rest of the unit.My temperatures were amazing once this cooler was installed, I've dropped to a 19℃ on idle temperature and a 54℃ under max load, I've also stressed this for 1 hour under OCCT and the hottest temperature I've seen was 63℃.I will have to say that DEEPCOOL has a winner here on their hands and I am going to be looking at their cooling options from now on based off the performance of this single item! Thanks for making a quality product that also looks good, and for those who hate RGB, you can SHUT the lights off!

the pictures don't even do it justice, it looks 10x better than the pictures, trust me, This thing will turn heads and add serious aesthetics to your rig that you didn't even think was possible. Gone are the days of ugly bland air CPU coolers, This bad boy is the same price as the Hyper 212 and performs just as good with added RGB! You cant beat that. If you are on the fence on choosing this or the Hyper 212, Get THIS! Its freaking awesome. Keeps my Ryzen 5 3600 at 32C on idle and in games it never exceeds 62C.The mounting system is fairly straightforward and easy to install. Nothing but a simple phillip head screwdriver is needed for assembly. The only downside is that I had to remove the GPU from the PCI slot in order to get the fan clips over the heatsink because there was no clearance between the GPU backplate and the heatsink for my hand to fit to pull the fan clip on, But it wasn't that big a deal.the wiring system is not great but I get that the RGB probably cant be powered by the CPU fan header alone hence why it needs a spare SATA plug from your PSU. Other than that I have no complains at all about the controller. It works, You have to remove your side panel when you wanna change the colors but thats fine.RECOMMENDATIONS: Remove your GPU before installing to make it easier for you to clip on the fan. Also buy some spare paste, the stuff that comes with it was very generic and in a plastic pouch.PROS+ Quet+ RGB looks amazing, very vibrant+ Keeps CPU at same temps as a Hyper 212 EVO+ Installation mounts were very easy to line upCONS- Had to remove GPU to install the fans- Instructions could be more detailed- Included paste is crappy

Kvalite, tyst, effektiv, men tänk på att den är hög så den gick inte in i min låda.. eller, tja, plexiglaset bågnar ut lite så det gick. Men det var ju mitt fel och inte kylarens..

The media could not be loaded.  Excellent ventirad RGB avec un rapport qualité-prix imbattable ! Après installation j'ai eu une baisse notable de la température cpu en jeu. J'ai fait un comparatif avec le ventirad d'origine d'Intel du processeur I3-10100F de ma tour. Comparatif fait sur Cyberpunk 2077 en qualité élevé et résultats extraits après une session de ~20min.⚠️De nombreux éléments sont à prendre en compte, mes résultats correspondent à ma config et ne sont pas à prendre pour une généralité. Entre les deux test j'ai par ailleurs rajoutés un ventilateur d'entrée d'air supplémentaire sur ma tour (réduction des températures globales 2 à 5°c max je dirais (différence observer sur la température de ma carte graphique GTX1660 super OC après 20min de jeu )Ventirad Intel = +80°c + Bottleneck à ~95% d'utilisation(par ailleurs le mod turbo du I3-10100F se désactive)Ventirad DeepCool Gammaxx GT BK= ~55-60°c, 50-70% utilisation (selon les lieux), le mod turbo fonctionne parfaitement.Si l'ont excepte le gain associé au ventilateur ajouter à la tour, le gain est d'environ 15°cLe RGB est simple mais efficace avec pas mal de couleur. Cela m'a permis d'avoir une config entièrement de la même couleur.Ma carte mère ne possède pas de port RGB pour contrôler l'éclairage du ventirad avec une application.J'ai donc opté pour le branchement sur l'alimentation du pc avec l'interupteur de sélection de la couleur et de l'intensité. Câble management un peu compliqué pour cette option mais c'est faisable.Bref, très agréablement surpris par ce produit. Reste à voir la durée de vie mais le tout semble robuste. L'installation est vraiment simple et de la pâte thermique est fourni .✅Compatible avec les Socket 1200⚠️Ps: Je précise que je ne suis pas un professionnel loin de là mais j'espère que mon avis vous sera utile malgré mon manque d'expérience dans le domaine.

Amazing cooler for the price and includes nice BLINK to it (RGB).I'm using it on Ryzen 7 3700x and I've tried couple of different configurations so bare with me bellow. Unfortunately have pictures only on my current one but I'm happy to answer questions if someone interested.So, I did following options:Opt1: Stock AMD Wraith Prism CoolerOpt2: DeepCool Gammax with one Stock RF120 fanOpt3: DeepCool Gammax with two DeepCool RF120 fansOpt4: DeepCool Gammax with two Arctic P12 (my current setup on the pictures)The noise levels are acceptable if the CPU isn't overclocked in all configurations except the stock AMD cooler. (To noisy for me in continuous gaming or working sessions)At the moment my CPU is overclocked to 4425 Mhz on all cores @1.3625v and max temp under load with AIDA 64 is 79C with fans at 90%If i load my CPU and extremely hot GPU to 100% simultaneously CPU temps are rising to 85C, but this 8s limitations of my case with the GPU (Corsair Carbide 275r & 5700 XT - XFX THICK III Ultra.My idle temp is 42 - 49C @4425 Mhz and 36-39C @3600Mhz.So my conclusion is:Gammax can handle mild overclock with stock fan on acceptable noise levels. If you have extra 120 mm fan you can add one as DeepCool include extra set of mouthing springs/brackets in the box.In my opinion is best looking Budget friendly CPU cooler, regardless if you're using the RGB or not.Hopefully this is helpful to someone! Stay safe!

Ich bin von einem 2600er auf den 3600er Ryzen umgestiegen. Habe das System bis dato prima mit dem Wraith Prism (Standartkühler vom 3700X) betrieben. Nach dem Wechsel musste ich aber feststellen, dass die neue CPU ganz schön heiß wird.Der Prism Wraith hat beim Zocken (BF5, Ultra, 3440x1440) die CPU bis 86°C erhitzt und hat dabei mit 3000 u/min gedreht. Das war für das Ohr nicht wirklich schön. Takt der CPU lag dann nur noch bei 3800Mhz.Durch den neuen Gammaxx GT liegt die Temperatur nun bei max 76°C und der Lüfter dreht bisher auf maximal 1150 u/min. Das ist eine wahre Wohltat. Von der Geräuschkulisse würde ich es als wahrnehmbahres, leises Rauschen beschreiben. In keinster Weise penetrant oder störend. Durch die knappe 10° Differenz bleibt der Takt der CPU nun auch im Bereich von 3950-3900Mhz.PBO also Precision Overboost ist im Bios aktiviert, manuell übertaktet ist nichts. Die Leistung langt mir. Bei Singlecore Anwendungen liegt der Boosttakt über 4000 / 4100 Mhz. Noch hatte ich nicht viel Zeit für ausgiebige Tests, aber vom ersten Eindruck bringt der neue Lüfter genau das, was ich mir gewünscht habe.Niedrige Temperaturen und DEUTLICH weniger Geräuschkulisse, durch die Verbesserung auch etwas höheren Takt und gleich mal 100Pkt mehr im Cinebench20.Im Desktopbetrieb läuft der Lüfter aktuell auf ca. 850 u/min. Die Peaks, welcher der 3600er mit sich bringt werden entspannt abgefangen. Die Temperatur bewegt sich irgendwo zwischen 40 und 60°C bei herkömmlichen Desktoparbeiten / Youtube / Netflix etc.Von der Lüfterkurve habe ich das ganze so eingestellt, dass erst ab 65/70°C der Lüfter langsam aufdreht (max 1200 u/min). Entsprechend habe ich im Desktopbetrieb so kein Lüfteraufdrehen mehr wahrnehmen können.Die RGB Beleuchtung sieht super aus und lässt sich über die Software von meinem ASROCK B450M Pro4 steuern.Das Gesamtsystem ist in einem Sharkoon TG4 mit 3 Lüftern In und einem Out (120mm). Diese laufen konstant bei 60% Geschwindigkeit (in meinen Ohren angenehm, daher lasse ich diese auch nicht weiter runterregeln).Das Gehäuse bietet Platz für maximal 160mm Lüfterhöhe, ich würde mit diesem Kühler nun von Maßarbeit sprechen. Größer dürfte er wirklich nicht sein :)Also Fazit - harmoniert super mit dem 3600er Ryzen, ist in meinen Ohren wirklich sehr leise und sieht echt klasse aus. Ich dachte ich trauere meinem Wraith Prism nach, weil der optisch wirklich ein Hingucker ist, aber das Thema ist definitiv erledigt, der Gammax GT ist optisch und leistungstechnisch ein deutlich besserer Nachfolger :)EDIT:Mittlerweile habe ich meinen Ryzen etwas undervoltet, läuft stabil mit 1.25V auf 4000 Mhz, dadurch liegt die CPU Temperatur jetzt nur noch bei 65°C - 72°C. Lüfter ist nach wie vor unglaublich leise, klare Empfehlung!!!

Ryzen5 3500の時から使っておりますが、クーラーはずっと一緒です。かなり冷やしてくれます。