Low Profile Tactical Picatinny/Weaver 45 Degree Pro Mount, 2.16" Long with 5 Slots

Nice mount for the money. Fits great, tight, straight, & sturdy but the screw top to add a top rail are a little weak. Be careful don’t over tighten the top rail. You won’t want to change the top rail once you get it on there.

Vary well made, good quality hardware.I bought this for a offset flashlight mount, but ended up using it for a red dot offset on my AR10. It fit under my vortex scope where a rear iron sight would normally fit.The angle is perfect for a offset red dot without having to move your head to find the dot after rotating the rifle from the magnified optic.I have ran around 300 rounds with it on and I have had no shift in zero on the red dot (Bushnell tsr-25)

Good buy!

Exactly what I needed. Used it to mount a reflex sight at 45 degrees on a .45 ACP carbine so I can co-witness along with a scope mounted on the top rail. The low profile puts it in a much better position than the standard profile, which puts it too high and too far to the left to view comfortably when shouldering the weapon.

Good item - not too bulky

Exact fit and spacing to get my MBUS sights in an operable position. My Nikon mounts and Scope needed more offset to clear the mbus for clearance.

The holes aren't tapped! You can't screw in!!And the rail section sold by the same company to screw in was drilled mis aligned by a mile. Worst quality on any product I've ever seen, even out of China. Even in 2020, China still can't meet the quality you would achieve if you worked alone out of your garage and eye-balled it, truly embarrassing.A basic assembly line makes this impossible. You drill the hole, toss in a bucket for the next station to tap. Even if the tapping station is skipped those packaging it should have half a dozen things to evaluate before slipping in a sleeve; checking that a step wasn't skipped (let alone performed properly) should be among the easiest things to spot. Whoever set up the operation should be ashamed of themselves.Buy any other product if your needs allow. The only reason to buy anything from this company is if you hate convenience and secretly hope that you'll need to re-drill and tap the product yourself, creating an excuse to buy some more tools for yourself.

Didn’t end up using it but I’m sure I will eventually